A trick I have used on male XLR connectors, and it would probably work
on others too, is to use a good old reliable wooden pencil with an
eraser on the end. Drill a hole in the eraser just big enough for the
male pin to be pushed into it with a bit of force. Push the pin in and
give the pencil a few turns, and the connector will look as good as
new. I haven't found a similar trick for female connectors.
jim
Please ignore all the changes in font in my message
- my email client does that just to mess with my head.
Jim Farmer, K4BSE
Mobile 678-640-0860
[hidden email] (spam blocked)
Personal web site:
http://home.mindspring.com/~jofarmer/index.htmlBoss lady:
http://www.kathysflute.com/Youngest daughter:
http://www.joyfarmerclary.com/"A people that values its privileges above its principles soon loses both."
Dwight D. Eisenhower, Inaugural Address, January 20, 1953
On 12/25/2014 8:10 AM,
[hidden email] wrote:
> I ran into this years ago it turned out to be the Plug and not the jack.
> a simple fix is to wrap a piece of fine sandpaper (600+ grit) and wrap it around the plug and twist.
> Some plugs seem to have a slight film on them ant this removes it
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
