Jettie, W6RFF
Just got my K3 back from the factory, as they did not put a filter in the sub RX. Last night and this afternoon I worked quite a few stations on 20 meters, and everything seemed ok. After dinner I turned the K3 on and it would not operate correctly and "HI SIG" appeared on the screen. Evidently there is a strong signal blocking the Main RX. The SUB RX seemed to be OK as I could tune in signals on 40 meter CW. Also there seems to be quite a delay after most buttons are pushed, and some do not work. Some one had commented, yesterday about a loud noise in their RX, but it had eventually stopped. Also the K3 will not transmit. I went through all of the configuration, and nothing had changed. (had problems getting into config mode). Any ideas??
Jettie B. Hill, W6RFF
Roseville, CA 95661-5008
916-783-0383
American Radio Relay League (ARRL)
Since 1938
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
