K3: Repair Broken Power Pole

[Bruce Beford-4]

The two screws in the "middle" of the right side panel hold the low voltage
regulators to the side, for heat sinking, IIRC. Take the top off and you
will see this. There are nuts inside to remove.
G,
Bruce/N1RX

-----Original Message-----
From: Elecraft [mailto:[hidden email]] On Behalf Of Jim
Brown
Sent: Saturday, May 31, 2014 6:49 PM
To: Reflector Elecraft
Subject: [Elecraft] K3: Repair Broken Power Pole

The plastic housing of the black power pole that is captive to the radio
is broken, so I'm trying to take it apart to repair it. I started taking
the right side panel off, removing all the perimeter screws, but there
are two in the middle of the side panel, and six years after building
these radios, I don't remember what I can remove without having a
problem.  This radio is my spare, minimal stuff in it. K3/100, no tuner,
no 2nd RX.

Suggestions?

73, Jim K9YC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]



______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]