Hello I have built an Rx antenna K9AY. It will, I like to have connect to my
k3. Is there anyone who can help mig.Jeg have pressed the rx antenna on my k3 There is also a rx in my display, but when I dial my k3 stand it and click in relays Frank OZ1GML ________________________________________________________________________________ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html |
Frank,
I am unable to fully understand your e-mail. I use a K9AY with my K3 for 160 Meters and also listen with it on 80M and 40m, which are bands I am not active on but monitor from time to time. I find the K9AY gives me an average 15 dB front to back ratio on 160M. I have not noticed too much of an improvement in Signal to Noise Ratio but the antenna is a great help in contests when working the western hemisphere as it attenuates our fellow EU stations. I also use it in listening to stations in other directions and find the front to back a help. As I live in a rural location it may be that the improvement in SNR is not as great as it would be in a more built up area. You need the converter board in your K3 to have a separate receiver input. I assume you have this. You may need a good separation between TX and RX antennas to use the K9AY for break in operation. In my case the separation is 60 M and I have no problems. Hope you find the K9AY works well for you. If you have any further problems perhaps you might try to better explain them. All the best with luck I will work you in CQWW this weekend. That is if I can get my inverted L up and running. Life is good or should perhaps one say life is sweet to avoid the commercial boys with their Tee Shirts. 73 Doug EI2CN -----Original Message----- From: [hidden email] [mailto:[hidden email]] On Behalf Of Frank Fendahl Sent: 26 November 2009 18:30 To: [hidden email] Subject: [Elecraft] K3 & Rx Antenne K9AY Hello I have built an Rx antenna K9AY. It will, I like to have connect to my k3. Is there anyone who can help mig.Jeg have pressed the rx antenna on my k3 There is also a rx in my display, but when I dial my k3 stand it and click in relays Frank OZ1GML ____________________________________________________________________________ ____ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html |
Free forum by Nabble | Edit this page |