K3 SN31's first contest

[AJSOENKE]

Hi everyone -
 
One main reason I got a K3 was to be more active in DX and Contesting, now  
that I'm semi-retired. I used to be a very active contester in the late 70s  
early 80s and stayed in it mostly as a club activity since. I was introduced to  
logging software with CT in it's early days and still have a CT V10.x on the  
computer. I truly became tired of the amount of time I spent getting a rig
ready  for interfacing to a contest software etc. lot of rigblaster and other
stuff  laying around to help out, but never much satisfaction. With a working
schedule  it was too much and mostly went by the wayside. My K2 was an
improvement and  made the listening a lot easier. Interfacing was somewhat easier but
still  required a lot of homework and interfacing. At least with the K2 it was
worth  the effort.
 
Ok,  This weekend I had a choice of working in the orchard, with the  fall
cleanup and yet another Santa Ana wind condition - or - taking a two week  old
K3 and bridging the gap to get it set up for contesting in CQWW CWDX. I had  
become tired of  CTs endless menus and tricky help files, still stuck  learning  
CT. With CT if I don't use it 4 times a year it's a whole new  learning curve
each time. I started in earnest Friday about 2pm and decided to  try one of
the softwares in the Elecraft Web Page. I want to try all of them,  but had
seen a lot of reference to N1MM and chose that to start with.  At  first glance I
was overwhelmed with the amount of info, but followed the getting  started
and Quick start guide to installing and upgrading the latest  version.  I was
really nice to see that the K3 had already been   formatted in the boilerplate.
It gives you a sense of
confidence it might  work sometime this week.  So, given about an hour to get
the software  installed and read the basics, I gave it a shot.
 
The rig was already connected to the computer and had the latest upgrade  
installed. The RS232 cable I used is a standard 9 pin interface with all 9 wires  
hooked up. I set the K3 CONFIG: PTT-KEY to rts-dtr, set up the software
config  to match ( I changed data rate to 38400  and port to 8N1 for the K3 )
 
It took less than 20 minutes to get the rig on the air with a contest  
logger. What an improvement!
 
CU in the contest, break time is over.
 
Al WA6VNN



**************************************Check out AOL's list of 2007's hottest
products.
(http://money.aol.com/special/hot-products-2007?NCID=aoltop00030000000001)
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com