This is almost certainly the case. Please check the 5-pin header between
the FP and DSP boards to make sure they're mated correctly. Its easy to
miss this.
Greg
AB7R
-----Original Message-----
From:
[hidden email]
[mailto:
[hidden email]]On Behalf Of Bryan
Sent: Friday, April 04, 2008 3:48 PM
To: Elecraft
Subject: [Elecraft]K3 SSB Operation Queston
Craig,
I had a similar problem with s/n 181, which turned out to be poor connection
with the front panel. It was cured by removing the front panel and
refitting it, taking care to make sure all the connector pins were made.
With original fault the rear panel connection of a microphone worked ok.
Hope this helps.
73 Bryan GM3AKF
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
