Greetings all:
Trying to put K3 SN 42 on SSB to make a few SS contacts, using an Elecraft
MH-2 Mic. I set up MIC SEL for FP:h and turned on the bias. I can adjust
the Mic gain and compression, and hear the results with MON turned on, and
see the CMP and ALC graphs function. It seems to require a very high
compression setting to get even two bars to light up with a loud voice, but
the ALC goes to 6 bars immediately with any speech and stays there until a
half-second or so after speech ceases. Big problem is: there is no RF
output from the radio at all.
Everything works fine on CW; whatever is wrong is associated with SSB.
Haven't tried data mode transmitting as yet.
Is there a special secret to getting SSB to work ? ? Yes, VOX/PTT is set
to PTT and the transmit indicator lights up.
TIA, Van W1WCG
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
