While carrying out the cw keying mod last week I noticed one of the top
cover standoffs was pretty slack and prevented me from tightening the
screw sufficiently. I made a mental note to go round all the screws and
check they were all secure - I remember the manual emphasising that
screening can be compromised by not securing screws sufficiently.
Finally got round to it today; maybe I was too gentle when I put my K3
together last December but I did find several screws needing a tweak and
some were pretty loose in fact. The radio has not been mobile or moved
much so my advice would be to go round with a screw driver and 6BA nut
driver a couple of months into service just to check everything's still
tight. The design is so good that all the fixings are easily accessible
without any hassle after removing the top and bottom covers, with the
exception of the ones underneath the KPA100 and for now I've ignored
those.....
Still having fun and looking forward to the second receiver.....
73, Stewart Rolfe GW0ETF (K3 145)
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
