K3: Sequencer Operations.

[Roger de Valle]

Can someone advise me if the KEYOUT-LP will still activate if the TX-INH is low (on the K3 ACC socket), I am looking for suitable way of introducing a sequencer into the keying chain, mostly to bypass mast head pre amplifiers. If any one has any suggestions I would be grateful to take them on board.

Regards. Roger
VK3ADE.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Don Wilhelm-4]

Roger,

Yes, I believe the KEYOUT-LP is active even though TX INH is asserted.
To test your sequencer, I strongly recommend using TX TEST - no RF is
transmitted, but all controls will occur normally allowing you to test
the sequencer timings in detail.

73,
Don W3FPR

On 10/29/2011 7:35 PM, Roger de Valle wrote:

> Can someone advise me if the KEYOUT-LP will still activate if the TX-INH is low (on the K3 ACC socket), I am looking for suitable way of introducing a sequencer into the keying chain, mostly to bypass mast head pre amplifiers. If any one has any suggestions I would be grateful to take them on board.
>
> Regards. Roger
> VK3ADE.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html