Your original problem (VOX=OFF and beep) could have been caused by
key-down at power-up.
Check and/or disconnect your keying lines. The K3 may then start OK.
If you key via the RS-232 port, you may have a computer or cable problem.
But you can't be sure until the K3 is unkeyed.
73, Paul W8TM
**********************
Adriano PY2ADR sed:
> After a 10 days trip i turned on my K3 and it was "blocked".
No buttons working, no rx, nothing. Only the displays were working,
on the lcd the msg: VOX=OFF and a continuous beep.
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
