K3 - Setup After Firmware Upgrade

[Joe Word]

What setup is required after firmware upgrade? Say 1.88 to 1.96b.

Should we do the Low and High TX Gain Calibration?

What else?


Joe  N9VX

K3  #841
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[KK7P]

> What setup is required after firmware upgrade? Say 1.88 to 1.96b.

In general, check the release notes to see what's been changed.
Controls or settings related to those functions might need to be
altered, and in any event should be verified.

In this case, MIC GAIN and VOX GAIN are probably going to be different
than what you were using before.

73,

Lyle KK7P

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com