Hello All,
I built S/N 1354 from a kit , with FW 3.25 , I have installed most of the mods. I operate digi modes some of the time and I need to set the shift to 1.25 instead of 1.50 to be centered in the IF strip. It's been this way ever since I built it. I'm not sure what I have setup wrong . All filters are 8 pole . With the new shift steps set to 10 hz the shift control knob needs to be set all the way to the left ( 1.28 ) to be centered. Also on 160 M when I rotate the RIT knob fast to change the frequency I have some kind of image, Not sure what this is ?? Thanks for your help 73 Ken K5DNL ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html |
Hi Ken. You can save two unique filter setups using the NORM knob.
1. First, hold NORM to clear any shift to give you a good starting point. 2. Now set desired WIDTH and SHIFT the FC to where you want it. 3. Now do a LONG HOLD of the NORM knob till you see <SAVE>. Rotate the knob while you have it pressed to the left to save your custome filter to setting 1. 4. Do the same process and rotate to the knob to the RIGHT to save setting 2. I do this for SSTV and PSK. Its a quick and easy way to recall a custome filter for digital modes. Also, If you use DXLabs (and I believe others can do this as well but its very easy in DXL) you can enter CAT commands by mode. So when I use WinWarbler and select PSK it automatically sets the shift and the BW, and power output to what I want. No need to go to the radio to make any changes. It just happens. Hope this helps! ------------------------- 73, Greg - AB7R Whidbey Island WA NA-065 On Thu Aug 27 10:51 , Ken Roberson sent: >Hello All, > >I built S/N 1354 from a kit , with FW 3.25 , I have >installed most of the mods. >I operate digi modes some of the time and I need to >set the shift to 1.25 instead of 1.50 to be centered >in the IF strip. It's been this way ever since I built >it. I'm not sure what I have setup wrong . >All filters are 8 pole . >With the new shift steps set to 10 hz the shift control >knob needs to be set all the way to the left ( 1.28 ) >to be centered. > >Also on 160 M when I rotate the RIT knob fast to change >the frequency I have some kind of image, Not sure what >this is ?? > >Thanks for your help >73 Ken K5DNL > > > >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: [hidden email]','','','')">[hidden email] > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html |
Free forum by Nabble | Edit this page |