K3 Split and P3

[vidi]

> In chasing PJ4B on CW on 20m, I put the K3 in Split. I was trying to find
> the station he was just working with the VFO B cursor and that worked
> fine.
> However if I pressed REV to listen, then the VFO B cursor became frozen; I
> could change VFO B's frequency, but the cursor would no longer move. And
> the
> only way I could bring the cursor back was to turn the K3 off and then
> back
> on. After that the VFO B worked correct until I pressed REV again. So far
> I
> can find no mention of this in the P3 Manual. Anyone know how to avoid
> this?
> Tom - W4BQF

I have the same experience and could get out of the problem by turning on
and off the P3
Vidi - ZS1EL

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Grant Youngman]

There was a firmware fix for this posted earlier today (or maybe yesterday?).  4.14 for the K3.

Grant/NQ5T


On Oct 11, 2010, at 3:31 PM, vidi wrote:

>
> I have the same experience and could get out of the problem by turning on
> and off the P3
> Vidi - ZS1EL
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html