I need some expert advice from the experts on this list-serve. Here is my situation:
Krx3 installed with following:
Config:
FL2 & 3 turned on (set to 6KHz, 2.8KHz, no offset, no gain)
KNB3 set to SUB NOR
KRX3 set to Ant=BNC (with external antenna connected)
SMTR OF for sub set
SMTR SC for sub set
SPKRS set to 1
SQ SUB set to 00
SUB AF set to NOR
VCO MD Sub calibrated
result: only white noise with sub RF and AF turned up.
Problem: L33 on the sub receiver board had one wire which was not soldered. I soldered it to the obvious spot but no difference.
Troubleshooting clues:
When I place a finger near L33, the sub receiver begins to receive signals. By touching an antenna wire to the pad where I soldered L33, sub receiver works. But touching antenna to J92 does not bring in any signals.
All the connectors with Sub In and Sub OUT boards seem to be making good connections.
Question:
Could K11 on the KRX3 not be switching?
w4ish
Bill
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
