Brian -
The IC command will return the status of the "TEST" setting. In the first byte, bit 5 will be 0 if normal, A if in test. See page 13 of the K3 & KX3 Programmers Reference.
73, Mike NF4L
On Apr 9, 2014, at 8:43 AM, Brian Alsop <
[hidden email]> wrote:
> I'm using the K3 for measurements and want it to be in the TX TEST mode.
>
> The software uses SWH18. However, it is a toggle. So if "*hit" happens and you have to run the data collection software again, it returns the K3 to the normal mode.
>
> I've scanned the manual looking for a command which does the same but is not a toggle. NADA.
>
> Any workarounds?
>
> 73 de Brian/K3KO
>
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 2012.0.2247 / Virus Database: 3722/6813 - Release Date: 04/07/14
>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html> Message delivered to
[hidden email]
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
