K3 Transmitter Gain Calibration Problem

[Joseph M. Durnal]

I'm building the K3 and getting near the end (hopefully).  When I
follow the transmitter gain procedures, it displays ERR TXF over VFO
B.  The watt meter showed that it was putting out 5 watts, but the
error message worries me.  Any ideas?

Thanks,
Joe
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Ed Muns, W0YK]

> I'm building the K3 and getting near the end (hopefully).  
> When I follow the transmitter gain procedures, it displays
> ERR TXF over VFO B.  The watt meter showed that it was
> putting out 5 watts, but the error message worries me.  Any ideas?

Did you look up the ERR TXF on the error listing in the manual?  Make sure
you've properly set up the filter parameters in the CONFIG menu, especially
the transmit filter which must be a 2.7 or 2.8 kHz filter.

73,
Ed - W0YK

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com