K3 Upgrade Kit Question

[Roy Morris-6]

I have the Rev B E850235 K3 KIO3 Digital I/O PCB installed in my K3.  Choke L1 has NOT been jumpered.  I sent an email to Elecraft at [hidden email] asking if L1 should be jumpered.  I never received a reply.  Roy Morris  W4WFB
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Eric Swartz - WA6HHQ]

Hi Roy,

You are OK. Rev B -IS- the new KIO3 Digital Remote I/O board. (Same as
supplied with the REMIOUPGD kit.)

L1 is not jumpered. It is replaced with a zero ohm resistor on this board.

73, Eric  WA6HHQ
-----


Roy Morris wrote:
> I have the Rev B E850235 K3 KIO3 Digital I/O PCB installed in my K3.  Choke L1 has NOT been jumpered.  I sent an email to Elecraft at [hidden email] asking if L1 should be jumpered.  I never received a reply.  Roy Morris  W4WFB
>
>  
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html