Good evening,
I've just started having a problem with the latest K3 Utility. When I
run the utility without the rig turned on it tries to connect at each of
the baud speeds as usual. If I turn the rig on (or indeed if the rig is
already turned on when I launch the utility) the program finds the
correct baud rate but then instantly locks up. The only way to exit s
via the windows task manager.
Tried on multiple ports, multiple baud rates on K3 and USB adapter,
nothing other than version of K3 utility changed since I last upgraded
the firmware. Windows 7 64-bit happened with the previous version of the
utility that was installed (hence downloading the new version).
I'm a little perplexed as the rig control works fine with the logger on
the same serial port.
Any suggestions?
73, Iain M0PCB
(patiently awaiting my new KX1 kit to clear customs...)
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
