Once additional connections and coax length is introduced into a load that
is not the same as the output impendence you will not see the same. I have
come to accept that the results will be different in-line, unless some
tuning is added to each measurement device to remove the circuit reactance
created by each device. I accept the difference and use remote tuning to
eliminate these issues.
Bill
K9YEQ
-----Original Message-----
From:
[hidden email]
[mailto:
[hidden email]] On Behalf Of Dohn Smythe
Sent: Sunday, February 20, 2011 11:10 AM
To:
[hidden email]
Subject: [Elecraft] K3 + W2
Is there an accurate way to utilize a W2 with the K3/ATU combo? Seems that
with the W2 between the output of the K3 and the Antenna, the peak reading
would not be accurate. Especially at QRO power settings. I don't remember
seeing anything in either of the menus that would assist with that.
73
Dohn Smythe N8EWY
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
