My K3 is not my main rig I use for FT8/FT4 but I did have it set up and
working fine with WSJT-X with Linux Mint 19.3. I use another rig that is
pretty mediocre on CW but not bad on SSB and digital for most of my FT8/FT4
work. I recently did a fresh install of Mint 20 64 bit (attempts at a
straight upgrade failed) and have not been able to get WSJT-X working with
the K3. The other rig, yes but not the K3. The setup is an old Dell
Optiplex 380 desktop, CAT through an RS232 cable and the two cables from
the computer to the K3 line in and out jacks. I use PulseAudio. CAT works
fine an I am able to receive signals but not well and little shows up on
the waterfall. The rig will go into transmit but no power out. I am using
the same settings in Pulse that I used before.
Has anyone else had this issue with Liunx based on 20.04?
73, Bill NZ0T
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
