"I found the WMTR LP and WMTR HP menus and made the appropriate adjustments.
My power output is now 96.7 to 99.4 watts on all bands except 10 meters.
The output on 10 meters is 91.0 on 28 and 91.6 on 29.7. Is this power
output on 10 meters normal?"
How are you measuring your actual power? Is your 50 ohm load still 1:1 SWR
at 10 meters (will impact readings if using an in-line wattmeter with
marginal directivity)? And how accurate is your external wattmeter? I've
found that a lot of wattmeters drop off in indicated power as you go higher
in frequency unless there is something in the design to compensate for this.
I think the most accurate way to measure power is to use a diode detector,
but you must still have a precision 50 ohm load, and also verify that your
voltmeter reads correctly using a precision voltage reference.
Phil - AD5X
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
