Dave,
It was puzzling. I had the same situation. Because I often
use the M>V tap and a number key to change bands, I found that I was
resetting my data mode to AFSK A.
When a frequency is stored in a memory regardless of the mode, SSB, CW,
or data,
the data mode in play at the time is stored as
well.
So, I went through all the "number key" memories and stored
them all again. Even though the mode stored is CW, I went over to
the DATA MD and made sure it was FSK D. Then I switched back to CW
and stored it, V>M and a number key.
It is a bit confusing, but I hope this helps.
73,
Bob - N9SF
At 02:10 PM 11/1/2008, you wrote:
Every time I switch to data
mode, the K3 comes up in AFSK A, which I never use. Is there a way to
have it default to FSK D?
Dave Hachadorian, K6LL
Yuma, AZ
.
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htm
Elecraft web page:
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
