|
|
My K3 SN 1502 has developed a power output problem. I am seeing anywhere from about 20 to 40 watts instead if the usual 110. I use it with a KPA500 and both have the latested firmware loaded. I do have the new syn board which was factory installed about a year or so ago. I have tried the transmitter gain calibration several times both 5 and 50 watts. It has failed several times with low output though it has completed both power levels fine a couple of times. However both times it reverted to low output pretty quickly. I have also tried reloading firmware a couple of times. Decided to step away and check here for any ideas. Short of taking the cover off and tightening screws and re-seating modules (which I plan to do in the morning) I'm fresh out of ideas.
73 Bill NZ0T
|
Locked
