K3 feature request - Stop the KAT500 Relay Switch in Split

[Ralph McClintock-3]

  The KAT500 relay switch over between two in-band segments is driving
me nuts. A lot of DXpeditions on 160 use 1823.0Khz for transmit
listening up 1-5khz. Every time the K3 goes from A RX to B TX, and back
again, it involves a cur-chunk from the KAT500 whether the tuner is in
Auto or Manual.  It happens where ever there is a segment boundary but
is particularly annoying in the DX portions of the CW bands. Would it be
possible to alter the K3's firmware to recognize a Split or XIT from the
K3 as a Transmit on B VFO or XIT only? I know it would not affect owners
of rigs other than the K3/K3s.
Tnx,
W1ZK

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]