I have seen lots of posts on the filter setup on the K3 with regards to gain and also changing the filter value entered compared to the value of the filter itself. I just installed the general coverage unit in the main receiver along with a 6khz filter. This brought me back to the filter setup question. Just wanted to get some input from elecrafter's and their filter setting setup's.
My K3 filter line up is a follows:
Main
2.7Khz stock 5 pole crystal filter offset at -0.76
6Khz 8 pole inrad filter (I purchased this filter as the general coverage receiver is installed)
500hz 8 pole inrad filter
400hz 8 pole inrad filter
250hz 8 pole inrad filter
Sub
2.7Khz 5 pole cystal filer offset at -0.90
500hz 8 pole inrad filter
400hz 8 pole inrad filter
250hz 8 pole inrad filter
One last question.....In the main receiver where the general coverage unit has been installed I added the 6khz filter. For some reason I installed the 6khz flter after the 2.7 on the K3 board. I really don't want to take the radio all apart but if the 6khz should be in slot 1 then I will.
Mike
VE3WDM
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
