Ron, no, it happens even when I move from 147.030 to 147.060. I even
stored the same freq in VFO B to be sure that didn't have something to
do with it. But I get the little click each time I rotate the vfo A
knob from one 2m mem to the next. Just to emphasize, this is not when
I'm tuning but when I'm cycling through memories in the M>V mode.
73,
Mike ab3ap
On 04/24/11 17:16, Ron D'Eau Claire wrote:
> Mike, It sounds like you have memories set up on both sides of 146 MHz.
>
> There is a relay that clicks when you shift L.O. frequency range from
> 144-146 and 146-148 MHz in the K144XV.
>
> Try tuning across 146 MHz with your VFO and see if you hear the same click.
> If so that would be it, but it should not click when changing frequencies
> within either the 144-146 or 146-148 ranges.
>
> Ron AC7AC
>
>
>
> -----Original Message-----
>
> When I use M>V and the vfo A knob to cycle through 2m memories I hear a
> relay click each time I move to a new 2m memory, even before hitting M>V
> to exit that mode. Is this expected? It doesn't seem necessary.
>
> Thanks!
> Mike ab3ap
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
