[K3] microphone question

[David Christ]

I came into possession of a Kenwood MC-50 Dynamic mike in the original box but probably not NOS.

Is this a suitable mike for the K3?

If so:

Is it better to use it at 600 or 50K impedance?

Any suggestions for equalization?


David K0LUM

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Don Wilhelm-4]

Kenwood dynamic microphones will work fine in the K2 - just turn the
bias off.
Use the 600 impedance setting.  The 50k is for tube mic preamp inputs.

73,
Don W3FPR

On 2/27/2016 1:14 PM, David Christ wrote:
> I came into possession of a Kenwood MC-50 Dynamic mike in the original box but probably not NOS.
>
> Is this a suitable mike for the K3?
>
> If so:
>
> Is it better to use it at 600 or 50K impedance?
>
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]