K3, nap3 program

classic Classic list List threaded Threaded
2 messages Options
Reply | Threaded
Open this post in threaded view
|

K3, nap3 program

Clifford Coleman
I think that I have done things correctly, however,  using crative labs
sound crd 0204.  I can see that when

 I open the nap3 program, I can see the IF out is putting the signals on
the screen.   cannot chnge the freqency with the K3 tuning knob.   Cannot
change anything on the nap3 program screen with the radio.   I sem to have
only the OUTPUT OF the radio on the Lp Pan screen.   The configure  button
on the program will not allow me to enter a com port in the comport box
and give me an error message that the "cat control is not connected to the
K3. I have enabled the KXV3 in the config on the radio   any suggestions?
cliff k9jts
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Reply | Threaded
Open this post in threaded view
|

Re: K3, nap3 program

Tony Estep
On Fri, Jul 6, 2012 at 7:42 AM, Clifford Coleman <[hidden email]>wrote:

> .... cannot chnge the freqency with the K3 tuning knob....

-----------
That's because you don't have CAT control set up. See the LP-Pan website
for instructions. If you want to fan your CAT connection out to more than
one port, you'll also need LP-Bridge. The software and instructions are on
the LP-Pan site.

Tony KT0NY



--
http://www.isb.edu/faculty/facultydir.aspx?ddlFaculty=352
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html