Strange situation has occurred while using K3 Memory Editor to load
memory frequencies for the 222-MHz xvtr.
Under CONFIG I turned on XV2 and add 222 and 28 for RF and IF and
0.10 for XV2 PWR and TRN2 but I get 22.xxx in the memory locations
instead of taking the 222.xxx frequencies I entered. The K3 tries to
transmit on 22-MHz with obvious out of band error.
Now if I use "BAND-UP" I can go to 222.xxx and it is using the last
entered frequency and xvtr settings?
But when I change memory selection using "M>V" it selects 22.xxx in
the memory locations that I entered my 222 frequencies. I have no
problem going to 2m or 1296 memory locations with "M>V"
OK there are two ways to fool a K3, so I direct enter my chosen
frequency and use "V>M" and it takes the 222.xxx frequency and xvtr
settings. Then I run into the problem of setting a repeater split
which has to use the Memory Utility for programing. OK I fool the K3
again by reading the K3 to the Memory Utility and changing the
repeater offset and then reading back to the K3. It only took me
40-minutes to make three channel entries for 222-MHz.
BTW the Memory Utility does not work for single entries and I have to
do a full read of all memory channels each time. Is there a bug?
73, Ed - KL7UW, WD2XSH/45
======================================
BP40IQ 500 KHz - 10-GHz www.kl7uw.com
EME: 50-1.1kw?, 144-1.4kw, 432-QRT, 1296-?, 3400-?
DUBUS Magazine USA Rep
[hidden email]
Coming Soon - "Kits made by KL7UW"
======================================
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
