K3 question: setting monitor level via serial port command?

[Dana Roode]

Hi all,

Does anyone know if there is a K3 serial port command to set the
monitor level?  I am using my K3 remotely and inadvertently set the CW
monitor level to 0 before I left my station today (it is 80 miles
away).  I have not seen a way to control this via TRX-Manager or Ham
Radio Deluxe.  I looked through the K3 Programmers Reference and
didn't spot it there either.

  Dana, K6NR
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[list1]

Hi Dana,
Right know the FN command that sets the four multifinction encoders is not
operational.  Recently, Wayne has released a separate MG command for mic
gain, and CP command for compression in MCU release 2.73.
But I don't see a command for monitor level yet.

Steve, W2MY

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com