K3 reset/reboot

classic Classic list List threaded Threaded
3 messages Options
M.
Reply | Threaded
Open this post in threaded view
|

K3 reset/reboot

M.
A good thought, and would make sense. On power on, it is in cw mode for a second then switches to LSB (rig is on 40m). Tried exercising all the buttons but no joy. The two VFOs do tune normally, so seems to be primarily limited to the pushbuttons.

Mike N4GU


>A common cure for this symptom is that one of the buttons on the front >panel
>might be stuck. Exercise anything that you need to push for a function >and see if it might clear up.

>John N1JM

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Reply | Threaded
Open this post in threaded view
|

Re: K3 reset/reboot

Tony Estep
>
>>A common cure for this symptom is that one of the buttons on the front >panel
>>might be stuck....
==========
Or maybe the front-panel connector has a pin that isn't making
contact. Maybe if you open it up and wiggle the front panel board....?

GL,
Tony KT0NY



--
http://www.isb.edu/faculty/facultydir.aspx?ddlFaculty=352
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Reply | Threaded
Open this post in threaded view
|

Re: K3 reset/reboot

Vic Rosenthal
I second this advice! Pull the front panel board and push it back into place.

On 3/23/2012 5:52 PM, Tony Estep wrote:

>>
>>> A common cure for this symptom is that one of the buttons on the front>panel
>>> might be stuck....
> ==========
> Or maybe the front-panel connector has a pin that isn't making
> contact. Maybe if you open it up and wiggle the front panel board....?
>
> GL,
> Tony KT0NY
>
>
>

--
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html