The trouble I reported yesterday (low receive sensitivity
with coax shield connected) disappeared after I performed
the Tx gain calibration procedure (at low power).
So I installed the KPA3 100 watt amplifier module, but now
the rig shuts down completely if I key it at any power level
requiring the KPA3 (i.e. above 12 watts). It does this with
two different well matched antennas and with a 50 ohm
dummy load.
73,
Chuck NI0C
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
