There is a CALIBRATE button press required to perform the calibration on
each page. "Next" moves to the next page, whether or not you've done the
calibration on the page you're leaving.
We need the ability to perform just the 5, 50, or 1 mW calibration without
having to perform calibrations at other power levels. I can't use "Next" to
imply "calibrate and advance".
73 de Dick, K6KR
-----Original Message-----
From:
[hidden email]
[mailto:
[hidden email]] On Behalf Of Don Wilhelm
Sent: Thursday, June 8, 2017 12:24
To: brian <
[hidden email]>;
[hidden email]
Subject: Re: [Elecraft] K3 s/n 8xxx won't do 50 W TX gain calibration
Brian,
I think that may be a K3 Utility "problem".
It has the capability to skip any of the gain calibration ranges. Try again
and observe all the buttons on each screen.
73,
Don W3FPR
On 6/8/2017 3:12 PM, brian wrote:
> It's been a bit since I've done this.
>
> It does the 5 watt calibration OK.
>
> It then goes to the 50 watt calibration menu. Hitting next doesn't do
> any calibration but instead brings up the 1 mW calibration menu.
>
> K3 with new synthesizers: FW 5.57/1.26/2.88/2.88
>
> Only thing I can recall happening since the last time it worked was
> upgrade to 5.57 et al.
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html Message
delivered to
[hidden email]
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
