Hello Elecrafters
After a 10 days trip i turned on my K3 and it was "blocked". No buttons working, no rx, nothing. Only the displays were working, on the lcd the msg: VOX=OFF and a continuous beep.
So after a few turn on/off i decided go to EEINT (reset the radio).
Well after that i opened the K3 utility to start the configs again. It was also not working. I tested the port and it was ok but the attempts to connect w/ the radio failed. Not even the msg "new hardware found" came up. I was using the KUSB cable (FTDI).
I decided to try another cable (PROLIFIC) after delete all old drivers and install it again.. It did recognize the new driver but still no conection w/ the radio.
Any clue of what is going on here? Anyone had the same trouble?
Any way to test if the radio is damaged ?
Everything was turned off and disconected during my trip.
Tnx in advance.
PY2ADR - K3 S/N 4795
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
