I agree with Chen on all points. For information's sake, I can tell you
I am running a K3/100 with a SignaLink-USB. Before that, I ran a K2 with
a SignaLink-USB. This is a very hands-free configuration, and I have
never had the slightest trouble with it. It is a lot less trouble than,
say, a Flex box, with its need for a good IEEE1394 card/port. (I also
ran one of these for about a year, and every once in a while it would
require serious attention.)
The IMIC Chen mentions is quite a bit less expensive (~$30) but doesn't
seem to allow as much control. If your demo is using a laptop and a
utility like DigiPan, the IMIC could make a very portable and
non-intimidating impression.
John Ragle -- W1ZI
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
