Hi Adam,
> With the K3 subreceiver installed and while using binaural
> audio output from both receivers, is there a provision so that
> a switch toggles between memory VFO A/B within one receiver,
> and not between (physical) main- and sub-receivers?
No. The subreceiver, if turned on, is controlled by VFO B.
>
> Example: If working a split DX pileup, can you set one
> receiver to the DX frequency, the other receiver to a
> frequency in the pileup and use a toggle to switch the pileup
> receiver between soft VFOs so that one can alternately listen
> to the pile with wide/narrow filters? Or, does one have to
> adjust the DSP/XFIL filter width on the pileup receiver?
The latter. However, this is very easy to do thanks to the K3's
DSP/crystal filter "presets." There are two presets for each mode, and
a full set of these for each VFO. Once you have presets I and II set up
for a given mode and VFO, you can quickly toggle between the two using
the "I/II" switch.
73,
Wayne
N6KR
---
http://www.elecraft.com_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
