Can someone assist? All went well with K3 until the very last calibration. After KPA3 install, the tx gain cal will not run above 12 w setting. 50w tx gain cal will not run and gives ERR TXG message. Tx gain cal will run correctly at 12w or below. KPA3 module problem?? Before I uninstall the KPA3, perhaps someone has an idea of something I am missing? I have checked all the other settings and all seem to be where they should be.
73, Mike K5NU
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
