Hello All,
From time to time the request comes up on how to use the empty second
antenna port without having to buy a KAT3. I have a suggestion for
someone who is able to put the time and effort to devise a hardware
add-on for the KANT3 board.
Refer to the schematic of the KAT3 ATU. If you ignore all the tuning
components (relays K1 to K17 and their 10n capacitors, L1 to L9, C1 to
C8) what you have left is three shift registers/relay drivers, 2 relays
(K18,19), a 5volt regulator and a few resistors and decoupling
capacitors. There is no microcontroller, its all done with a 24bit
shift register.
The TPIC6C595Ds could be substituted with 74HC595s and two transistors
to drive the two relays, though watch out for the different pinouts of
the chips.
I suppose it could be done as two sub boards attached to the KANT3 - one
with the shift registers at the mainboard connector end, the other with
the relays, bleed resistor and spark gap near the antenna connector.
Best of all, no toroids to wind.
Unfortunately I don't have the time etc. to do this at the moment as I
am currently prototyping the ultimate accessory for my K3-a new shack to
house it in.
Any further comments and suggestions welcome.
73 de David VK5DG
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
