Hello Tim,
I am not sure the answer but I am sure you will lose the manual notch within AGC loop in the IC7600.
If there is a strong carrier right next to your weak SSB signal, a manual notch within AGC will notch out the carrier and bring up the weak SSB signal. In other words, the de-sense in AGC by the strong carrier will then be much reduced in IC7600.
Of course, you can also solve this problem by turning AGC off. However, Icom's manual notch within AGC is particularly good in this specific application.
TNX & 73,
Johnny VR2XMC
________________________________
寄件人︰ Tim Hague <
[hidden email]>
收件人︰ "
[hidden email]" <
[hidden email]>
傳送日期︰ 2012年09月20日 (週四) 9:59 PM
主題︰ [Elecraft] K3 v IC7600
Hi. I've recently acquired a KX3 and have noticed that in my very noisy location the KX3 has the ability to hear signals that the IC7600 just can't, specifically on 80M where plasma TV interference rules supreme.
I'm not using the noise blanker on either rig by the way.
My question is would I see a similar improvement if I was to sell the IC7600 and replace it with the K3,
Best regards, Tim Hague
Sent on my iPad
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
