Mine(1.2.3.14) has NEVER failed to return the K3 to its pevious
settings. Which version of the utility are you using? How does the
Palstar hook up to the K3?
73, Mike NF4L
Bill Miner wrote:
> FYI
>
> Just in case someone else has this same problem, I loaded the latest K3 firmware onto my rig and when the load was complete I found that my K3 would no longer control the Palstar tuner.
>
> It seems that the K3 Utility does not return the RS-232 port back to the original baud speed setting that was used before the down load when it is finished. After I reset the RS-232 port speed back to the original 9600 setting then the Palstar tuner started tracking again.
>
> 73,
> Bill - K6WLM
> KX1, K2, K3-100k
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
