K3S Macro Programming - Rotating Macros

[Byron Peebles]

I am trying to program my first "Rotating Macro", where the PF1 Button
will set SPLIT+1 the first time it is pressed and held and it will UNSET
SPLIT the second time it is pressed and held.

I am basing this on the work by W8TN and LA3ZA, and others who have
offered support here.

I have had PF1 as SPLIT+1 and PF2 as SPLIT+5.  They are saved in MACRO1
and MACRO2, respectively.

I am trying to add MACRO3 and MACRO4 to CLEAR SPLIT and set to SPLIT+1
and SPLIT+5 again.

I added the following to MACRO1 based on the Programmers reference:

MN110;SWT20;SWH18;SWT14;

#20 is listed as MACRO3, #18 is listed as PF1.

But, the SPLIT part of the MACRO works, but the MACRO is not
reprogrammed.  So, little joy.

When I execute the MACROs from K3 Utility, the reprogram things fine.  
But not when I hold the button.

I hope I don't have to "add" these in CONFIG every time.  That doesn't
make sense.

(100) 72, Byron




______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Byron Peebles]

This is an RTFM problem.

I was confusing the KX3 Table with the K3 Table.

When I used the proper values from the K3 Table, it worked perfectly.

73, Byron

MACRO1-4: #11, 12, 13, 24
PF1-PF2: #45, 47

On 08/13/2015 08:14 PM, Byron Peebles wrote:

> I am trying to program my first "Rotating Macro", where the PF1 Button
> will set SPLIT+1 the first time it is pressed and held and it will
> UNSET SPLIT the second time it is pressed and held.
>
> I am basing this on the work by W8TN and LA3ZA, and others who have
> offered support here.
>
> I have had PF1 as SPLIT+1 and PF2 as SPLIT+5.  They are saved in
> MACRO1 and MACRO2, respectively.
>
> I am trying to add MACRO3 and MACRO4 to CLEAR SPLIT and set to SPLIT+1
> and SPLIT+5 again.
>
> I added the following to MACRO1 based on the Programmers reference:
>
> MN110;SWT20;SWH18;SWT14;
>
> #20 is listed as MACRO3, #18 is listed as PF1.
>
> But, the SPLIT part of the MACRO works, but the MACRO is not
> reprogrammed.  So, little joy.
>
> When I execute the MACROs from K3 Utility, the reprogram things fine.  
> But not when I hold the button.

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]