K3S TNX INHIBIT & WSJT-X

[stengrevics]

To provide enough time for relays protecting a preamp to switch, I have enabled TNX INHIBIT on the K3S.

Does anyone know if operating WSJT-X disables TNX INHIBIT or effects it in any way?

73,

John
WA1EAZ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Bob Wilson, N6TV]

Did you use set CONFIG:TX INH to Lo=Inhibit?  What are you connecting to K3
ACC pin 7 to inhibit transmission?  Did you supply 5V to that pin through a
current limiting resistor or did you get it from Pin 1?

For a safe sample SO2R TX inhibit circuit, see https://bit.ly/K3lockout .

But perhaps all you should do is increase CONFIG:TX DLY or your PTT IN
delay.

73,
Bob, N6TV


On Wed, Nov 7, 2018 at 12:47 PM John Stengrevics <[hidden email]>
wrote:

> To provide enough time for relays protecting a preamp to switch, I have
> enabled TNX INHIBIT on the K3S.
>
> Does anyone know if operating WSJT-X disables TNX INHIBIT or effects it in
> any way?
>
> 73,
>
> John
> WA1EAZ
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to [hidden email]
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]