Well it turned out that I had the audio codec set to mono in the PC, so it was simple. It seems to work now. MR in a few minutes so we will see.
73
Conrad PA5Y
-----Original Message-----
From:
[hidden email] <
[hidden email]> On Behalf Of Conrad PA5Y
Sent: 12 January 2020 00:51
To:
[hidden email]
Subject: [Elecraft] K3S USB codec Main and Sub - Left and Right
Hello all.
I have 2 independent Xpol channels that I want to decode separately. I have tried unsuccessfully to achieve this.
Details are as follows
Xpol yagi - CH1 is -45 deg, CH2 is +45 so in an X format
2 channel 144/28 transverter
Ch1 is Main - Ch2 is Sub
What I want to do is use the USB codec and the left channel for the main and the right for the sub RX, WSJT-X allows for selection of left or right channel on a stereo audio stream. If I use my soundcard this works fine.
BTW I do not need a coherent RX, I am not trying to do adaptive, I achieve this by splitting the 28 MHz channel and use a coherent 2 channel SDR, this work FB as well.
It must be possible I think but I can't figure out how. Any advice would be appreciated.
73
Conrad PA5Y
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html Message delivered to
[hidden email]
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
