All equipment factory built/aligned K3s to KPA500 using KAT500.
Had the setup about 6 months now.
When first tuned up on any band SSB or CW mode, with 5 watts K3 drive,
it takes a short transmission at 15 watts K3 drive for the amp to ramp up to 500 watts as read on the KPA500.
It stays at that level until a frequency or band change occurs.
A short transmission and it ramps up to full output power again.
A CW ID is usually sufficient to ramp the power up to 500 watts.
Is there a tweak that needs to be done, or should I leave well enough alone?
Leroy AB7CE
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
