KAF / KDSP2: Straight swap, or any gotchas?

[Andrew Moore-3]

A fellow list member and I have are swapping each other's KAF / KDSP2.  Each
has been installed and operational in their original K2's (i.e. the initial
mods have been done to the control board... removing resistors, etc.)

Assuming firmware and hardware is up to date, should we be able to simply
swap these boards into our K2's without any additional mods or component
replacement on the K2 control board?  I'm pretty certain the mounting
hardware is the same; I'm thinking more like resistors, capacitors, jumpers,
etc...

Thanks,
--Andrew, NV1B
..
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Don Wilhelm-4]

  Andrew,

Just remove one and put the other one in - no problem.

73,
Don W3FPR

On 2/12/2011 1:45 PM, Andrew Moore wrote:

> A fellow list member and I have are swapping each other's KAF / KDSP2.  Each
> has been installed and operational in their original K2's (i.e. the initial
> mods have been done to the control board... removing resistors, etc.)
>
> Assuming firmware and hardware is up to date, should we be able to simply
> swap these boards into our K2's without any additional mods or component
> replacement on the K2 control board?  I'm pretty certain the mounting
> hardware is the same; I'm thinking more like resistors, capacitors, jumpers,
> etc...
>
> Thanks,
> --Andrew, NV1B
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html