Would someone be so kind as to take some measurements of the KAT100-1 Antenna
Tuner:
The horizontal distance between the center of the Antenna 1 SO239 connector
(J5) and the center of the Antenna 2 SO239 connector (J6).
The horizontal distance, parallel to the back panel, from the center of the
Antenna 2 SO239 connector (J6) to a projection of the outer edge of the left
side panel. In other words, how far in is the center of the Antenna 2 SO239
connector from the outside edge of the left side panel?
The horizontal distance, parallel to the back panel, between the center of the
Antenna 1 SO239 connector (J5) and the vertical center line of the ground
screw (E1).
I am building a new feed-through panel and want to make it line up properly
with a KAT-100-1 which I have not yet purchased. There will be short runs (2
inches or so) of coax between the feed-through panel and the tuner, so the
measurements don't have to be exact. The coax will compensate for a slight
offset.
Thanks in advance!
Darrell VA7TO K2#5093
--
Darrell Bellerive
Amateur Radio Stations VA7TO and VE7CLA
Grand Forks, British Columbia, Canada
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
