When using my KAT100 with my K2/100 I am getting a "HI REFL" message
on the K2 display. The tuner will auto tune to 1.0-1.1:1 with no
problem. But when I key the transmitter above 50 watts, the message is
displayed and the output goes to zero.
I found an open diode at D2 in the SWR bridge circuit of the KAT100.
After replacing D1 and D2, inspecting T1 and its connections, and
recalibrating the SWR bridge, it worked fine yesterday during a one hour
QSO with my friend in OR. Last night I tried it and the "HI REFL"
message came up once again. The K2/100 works fine into a dummy load and
while using a manual tuner on an antenna. Three different antennas give
similar results on the 80, 40, 30 and 20 meter bands. I haven't tried
other bands but assume the results would be the same.
The K2/100 and KAT100 are grounded via a copper strap, approximately
7 feet long, to an 8 foot ground rod therefore I don't suspect stray RF.
I'm at a loss determining where to check next and would appreciate any
help.
73,
Sam, KL7V/5
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
