I didn't find my original posting anymore so I couldn't reply to the
original thread.
I took a sharp knife and took away some very thin plastic layers from
the surface of J4 (16-pin connector). Plastic was removed above the pins
from 7 to 10 and number 16. Now J4 is sitting perpendicular to circuit
board.
Capacitors are right, marked "102". Maybe this occurred problem could be
avoided by installing and soldering U1 socket about 0.5mm nearer to
circuit board edge. If there is some "tolerance" in the bottom of U1
socket and it's holes.
I'd suggest this could be included to the errata sheet.
Rolf Moberg
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
