KAT500 and a FTdx1200

[k6mkf]

Hi Gang,

 

I'm helping a relatively new Amateur who just ordered a KAT500 for use with
her Yaesu FTdx1200.

 

I've read the Elecraft paper: 'Yaesu FTdx1200 with KPA/KAT500 Power Combo'
which describes the setup for the KAT500 Basic Mode with the FTdx1200.

 

I'm wondering if there is a way to establish a more robust interface between
the FTdx1200 and the KAT500.  

 

The FTdx1200 presents BAND DATA A, B, C & D at the rear panel LINEAR 10 pin
output jack.   I'm wondering if anyone has used this data to interface with
the KAT500.

 

Thanks in advance for your assistance!

 

- 73 and good DX de Mike,  <http://www.qrz.com/db/k6mkf/> K6MKF, Past
President -  <http://ncdxc.org/index.html> NCDXC

 

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]