OK ... you're talking about the K2"S" software ... kinda confusing there
for a sec.
The program has not been updated (as far as I can tell) since 2003.
Have you tried running the program under COMPATIBILITY MODE? Right
click on the software's icon to bring up the menu and select
PROPERTIES. Then select the Compatibility tab. On that tab you'll
find a button for the "Run Compatibility Troubleshooter". It should
fix the issue. If after it runs, you still have the problem, try
setting the compatibility manually, by clicking on the box in that tab,
and selecting Windows 7.
Hope this helps,
Neil, KN3ILZ
On 12/27/2019 7:36 AM, Steve & Anne Ray wrote:
> I have been using Dan's excellent K2S software for my K2 with Windows 7 for
> a number of years. I recently upgraded my computer to Windows 10. Now
> when I load K2S I get the following error message. "Unable to read software
> logging model". The program comes up, but does not respond to any
> commands. I know my serial interface is good as it works with my K2 on the
> SKCC and NAQCC logging programs. Does anyone have a solution, so I can use
> Dan's excellent program.
>
>
>
> 73,
>
> Steve K4JPN
>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
